Knots, rope systems, and fixed-line technique
On Everest you spend most of the climb attached to fixed ropes by a harness, a safety tether, and an ascender. The central rule is simple: you are never unclipped from the rope, not even for a second. Everything below supports that rule.
Essential knots
Learn these from a qualified instructor, then practise until you can tie them with gloves on and eyes closed.
| Knot | Use | Notes |
|---|---|---|
| Figure-eight follow-through | Tying the rope into your harness | The most important climbing knot; always check it with your partner |
| Figure-eight on a bight | Making a loop to clip into an anchor | Strong, easy to inspect |
| Clove hitch | Quick, adjustable attachment to a carabiner | Useful at anchors |
| Munter hitch | Belaying or lowering with just a carabiner | Backup if you drop your belay device |
| Prusik knot | Friction hitch on a rope; grips when loaded | Used for crevasse rescue and as a backup ascender |
| Double fisherman's | Joining two ropes or making a prusik loop | Very secure |
| Overhand on a bight | Simple loop, stopper knots | Tie a stopper knot at rope ends when rappelling |
| Girth hitch | Attaching slings to harness or objects | Quick, but weaker than other methods |
Your personal system on the fixed rope
- Two tethers (cowtails): made from dynamic rope or purpose-made lanyards, attached to your harness. One ends at your ascender (jumar), the other at a locking carabiner.
- Ascender (jumar): a handled clamp that slides up the rope but grips when pulled down. You push it up, step up, repeat.
- Rappel device: a figure-8 descender or an ATC-type belay device for descending steep sections.
Passing an anchor (the key move)
Fixed ropes are tied to anchors (ice screws, snow stakes, rock bolts) every 20-50 m. To move past an anchor without ever being unclipped:
- Arrive at the anchor. Your ascender and carabiner are both clipped to the rope below it.
- Unclip the carabiner and clip it to the rope above the anchor. You are now attached above the anchor.
- Remove the ascender from the rope below the anchor.
- Attach the ascender to the rope above the anchor.
- Check both are closed and locked. Continue.
At every moment, at least one attachment is on the rope. Practise this in thick mitts until it takes under 30 seconds.
Descending fixed ropes
- Gentle slopes: walk down facing out, clipped with a carabiner, holding the rope with an arm wrap (rope wrapped around your forearm for friction).
- Steep slopes: rappel with a figure-8 or belay device, with your tether carabiner also clipped as a backup. Tie into the new rope section below the anchor before unclipping from the one above.
- Never rappel on a single old or damaged rope without checking it. Old ropes from previous seasons sometimes remain on the mountain; use only the current season's lines as instructed by your guide.
Crossing ladders
The Khumbu Icefall has ladders laid horizontally over crevasses and vertically up ice walls.
- Horizontal ladders: clip into the safety ropes on both sides. Place crampon points across the rungs so the front and back points catch two rungs. Look at your feet and the rungs, not into the crevasse. Keep the safety ropes slightly tight to stay balanced.
- Vertical ladders: clip your ascender to the fixed rope beside the ladder and climb steadily, moving the ascender up as you go.
- One person at a time on each ladder section unless your guide says otherwise.
Passing and being passed
When passing slower climbers on a fixed rope, do it at an anchor if possible, and always stay clipped: clip your carabiner past them first, then move your ascender. Speak clearly, be patient, and never unclip to overtake. On summit day, overtaking is often impossible, which is why the start time matters so much.