Supplemental oxygen systems
A supplemental oxygen system has four parts: a high-pressure cylinder, a regulator that sets the flow, a hose, and a mask with a reservoir. Operators supply the system, but you must know how to use, check, and troubleshoot it yourself, because a failure at 8,500 m is a life-threatening emergency.
How the system works
Oxygen flows continuously from the cylinder through the regulator into a reservoir. When you breathe in, you draw oxygen from the reservoir. One-way valves stop your exhaled breath from going back into the reservoir. This basic design traces back to the mask developed by Tom Hornbein for the 1963 American expedition (Alan Arnette).
Main brands and components
| Component | Common options | Notes |
|---|---|---|
| Cylinders | Poisk (Russia); Summit Oxygen (UK); some operators' own designs | Composite, lightweight, high-pressure bottles |
| Regulators | Poisk; Summit Oxygen | Set flow in steps up to about 4 L/min |
| Masks | TopOut; Summit Oxygen; Poisk | Mask design strongly affects efficiency and freezing |
For many years, most Everest teams used Poisk bottles and regulators with TopOut masks, while a few, like IMG, used their own designs (Alan Arnette). Some operators have since switched to the Summit Oxygen system, which one operator described as more reliable and lighter than the regulators it used before (Alpenglow Expeditions). Ask your operator which system they use and practise with that exact system.
Cylinder numbers (typical example)
One commonly quoted example: a 4-litre cylinder filled to about 4,300 psi holds roughly 1,200 litres of oxygen and weighs about 3.8 kg full (MountEverest.info). Duration depends on flow:
| Flow rate | Approx. duration of a 1,200-litre cylinder |
|---|---|
| 0.5 L/min (sleeping) | About 40 hours |
| 1 L/min | About 20 hours |
| 2 L/min | About 10 hours |
| 3 L/min | About 6.5 hours |
| 4 L/min | About 5 hours |
These are simple calculations. Real duration is lower because of leaks, cold, and never being able to use every last litre. Most clients use about 5-7 bottles in total for the summit push, depending on the operator's allowance.
Checks before every use
- Cylinder pressure gauge: confirm the bottle is full before leaving camp.
- O-rings: check the rubber seal between regulator and cylinder; a damaged O-ring causes leaks.
- Fit: screw the regulator on hand-tight, carefully, keeping face and eyes away from the connection.
- Flow test: set the flow and listen and feel for oxygen reaching the mask.
- Mask seal: adjust straps so the mask sits firmly with goggles fitting over or around it.
- Hose: check it is not cracked, kinked, or trapped under pack straps. Summit Oxygen's investigation of the 2018 regulator failures found that some problems came from broken O-rings or hoses stepped on with crampons (Alan Arnette).
Common problems and fixes
| Problem | Sign | What to do |
|---|---|---|
| Regulator failure | Loud hissing, oxygen escaping | Swap to a spare regulator immediately; tell your guide |
| Frozen valve in mask | Breathing feels harder; bag does not fill | Knock ice out of valves; switch masks if possible |
| Empty bottle earlier than expected | Pressure gauge near zero | Change bottle; report to guide; plan descent |
| Mask leaks | Goggles fogging; cold oxygen on cheeks | Adjust fit; tighten straps |
| No oxygen at all high on the mountain | Sudden breathlessness, weakness | Emergency: tell guide, descend, share oxygen if possible |
Safety rules
- No flames, oil, or grease near oxygen equipment. Pure oxygen makes materials burn fiercely.
- Never drop cylinders; store them upright and secured.
- Carry out empty cylinders. Most operators now collect and return them for refilling or recycling (Section 25).